- Title
- Flow characteristics of the molten mix generated during iron ore sintering
- Creator
- Liu, Dongmei; Loo, Chin Eng; Evans, Geoffrey
- Relation
- ARC.LP110100498 http://purl.org/au-research/grants/arc/LP110100498
- Relation
- International Journal of Mineral Processing Vol. 149, p. 56-68
- Publisher Link
- http://dx.doi.org/10.1016/j.minpro.2016.02.008
- Publisher
- Elsevier
- Resource Type
- journal article
- Date
- 2016
- Description
- In a sintering bed the generation of melt in the descending flame front causes the coalescence of material and the transformation of the particulate bed. Interspersed between the large voids are the densified lumps of sinter which are released on crushing and used as blast furnace feed. The bed transformation process is critical in sintering and is an outcome of the work done on the material by the surface and opposing viscous forces. Less densified, weaker sinter forms when the level of coalescence achieved is low. The process is extremely complex in that it involves a three-phase melt–solids–gas system. In this study, the composition of the sinter bed was simulated using the pressed cylinders of laboratory grade chemicals and the coalescence process was studied by characterising the densification of the cylinders. The alumina, magnesia and basicity of the cylinders were altered (1–4%, 0–2% and 0–3, respectively) to change the properties of the melt and also its solid content. The estimation of solid–melt content, melt composition, viscosity and surface tension was obtained using a thermodynamic model (FactSage) and the reported equations in the literature. Using these results Laplace number of the system was determined as a function of temperature. At the completion of some tests the cooled solidified samples were studied under a microscope. The experimental results showed that the higher sinter density and densification factor were obtained when temperature and sinter mix basicity increased and alumina levels decreased. The effect of magnesia level on densification was less because the porosity of the cylinders altered with magnesium carbonate levels. The trends obtained in sinter densification are consistent with the micro-structural information indicated by optical micrographs. The use of Laplace number to quantify the relative influence of the surface to viscous forces on coalescence was encouraging with a prediction error within ± 10%. It was also concluded that the most influential factor determining densification factor was the apparent viscosity of the molten mix as the change in surface force was comparatively small.
- Subject
- iron ore sintering; molten mix; flow characteristics; coalescence; desification; laplace number
- Identifier
- http://hdl.handle.net/1959.13/1337539
- Identifier
- uon:27867
- Identifier
- ISSN:0301-7516
- Language
- eng
- Reviewed
- Hits: 1484
- Visitors: 1477
- Downloads: 0
| Thumbnail | File | Description | Size | Format |
|---|