Please use this identifier to cite or link to this item: http://hdl.handle.net/1959.13/25126

OpenURL Link
Title
Aggregate size and density after shearing, implications for dewatering fine tailings with hydrocyclones
Author/Creator
Franks, George Vincent;  Yates, Peter Damian;  Lambert, N W A;  Jameson, Graeme John
Description
Experiments have been conducted in a shear cell in order to provide insight into the separation of floes by size and density in a hydrocyclone. The size of the aggregates was measured after shearing at a rate comparable to that found within a typical hydrocyclone. Two types of coal tailings from the Hunter Valley, NSW Australia with average sizes of about 0.4 mu m and 10 mu m were investigated. The size of aggregates after shearing was measured for a range of different polymeric flocculants of varying molecular weight and charge density. Under certain conditions 90% of the aggregates from the submicron tailings have size greater than 38 mu m after shear at 1200 s(-1) for 30 s. The aggregates produced from the 10 mu m tailings had over 90% larger than 82 mu m with the flocculants tested. The size of the aggregates remained sufficiently large after shearing to be suitable for hydrocyclone dewatering. The density of the aggregates was calculated from the aggregate size and mass fractal dimension. The small difference between the density of the aggregates and water was found to be the factor limiting their velocity under the applied centrifugal acceleration. (c) 2005 Elsevier B.V All rights reserved.
Relation
International Journal of Mineral Processing Vol. 77, no. 1, p. 46-52
Date
2005
Publisher
Elsevier
Keyword(s)
flocculation;  dewatering;  hydrocyclone;  fractal dimension;  separation;  breakage;  flocs
Resource Type
journal article
Identifier
http://hdl.handle.net/1959.13/25126
Identifier
ISSN:0301-7516
Language
eng
Reviewed
Reviewed
48 Visitors 51 Hits 0 Downloads
Save/E-mail Citation
Citation Format
E-mail Address
Subject
"International Journal of Mineral Processing"
 
OR